We’re releasing our 2.46 app today with the ability to set a motion detection zone in landscape mode on Wyze Battery Cam Pro! We’re also releasing Wyze Cam Outdoor Base Station version 18.104.22.1686 with support for automatic updates.
I think this is only the necessary firmware change to allow automatic firmware updates for WCO base station. Looks like it will need a corresponding app update too. Either that or it’s a WCO base station firmware update to allow WCO cam firmware update passthough.
Wyze has been rolling out user-controlled firmware update options for cam types for a few months now. I turned it on for this WCO cam for illustration… I normally select “off” to manually control the update process. Automatic firmware updates has been requested by the user community via wishlist. Check your cams via Settings > Device Info > Firmware Version.
WCO v1 & v2 cams (WCO base station not yet available):
I have 1 of 5 WCO cams set to auto update just to test this thing out. No updates available to test this though. I’d flash back to previous version just to test it, but need some specifics from Wyze before messing with it.
I only have one V3 Pro, 4 Version one WCO and Base/ and 4 V3 cams. Hope I didn’t forget any. I like to wait and see if firmware updates have had bad effects on other users before I get brave enough to try. I always check for Forum after updates and wait a few days until the dust settles.