After the firmware update, my Pan v2 camera bricked up and the light stayed red. I could not reinstall it as the setup button would do nothing… not even factory reset it. Wyze is sending me a replacement and said it’s a known issue that has affected some Pan v2 cameras. As an aside, a brand new Pan v2 arrived today from Amazon. It refused to set up right out of the box. I pressed the setup button and there was dead silence… no “Ready to Connect,” nothing! It’s going right back to Amazon. I think I’m done with the Pop an v2 cameras until they get it right. I’m crossing my fingers that the replacement that WYZE is sending me works and setup actually does setup the camera.
[Mod Edit] Relocated to the correct firmware thread.