I’m seeing a 4 second pause around the 2 second mark in my events and playback. Then it starts again, skipping a few seconds ahead. This is happening on one v2 and two v3 cameras, all with Cam Plus. It is not happening on my Video Doorbell Pro with Cam Plus and not on my v2 camera with Cam Plus Lite (12 second events).
This has been happening for at least a couple of weeks.
The V3 Firmware was halted for “Event Recording Issues” on Nov. 10
I haven’t been following the V2 updates closely because I don’t have any. However, I do recall the same issues previously occuring with the V2 and the PanV1 when they pushed firmware with the newly developed “Edge AI” in it. One can only speculate, but I have my suspicions.
It is all documented in the “Wyze News” section of the forum. I was just being silly in the above post with SlavSlayer. If you are on 22.214.171.124, fear nothing my friend, you are in good hands. If you are on a newer one give a minute and I’ll fish out the info for you.
I have updated my two v3 cameras to the latest version 126.96.36.19906 and the issue seems to be completely fixed on one of my cameras, but the other camera is still recording a very short pause (less than a second) about 4 seconds in.