After firmware update cameras don't connect anymore

[StevenA]

I would try following the steps in the 2nd post on this thread by SlabSlayer. It is somewhat tricky to manually flash.

Wyze Cam V3 Pan - Failure to flash firmware

I’ve been trying to update a Wyze Cam Pan V3 firmware and I’m at a loss. It will not update via the app, crashes every time. I’ve got a clean MicroSD card, so I followed the instructions to load the most recent firmware on it to update manually. However, there is never a point where the light is anything but red. The instructions say: " 1. Hold the setup button, plug in your USB cable, keep holding the setup button for 3-6 seconds until the light is solid purple, then release the button. No…