Wyze sense V1 - Design flaws

[carverofchoice]

@davsav

Have you tried the workaround suggested in the Advisory of resetting the device when powering it up?

Looks like it would just take holding the reset line on the CC1310 chip high while applying power to the device.

You will be interested in reading through the following thread on the topic of people actually doing this:

Unbricking Wyze Contact Sensor - pcb reset pin

Hello, the forum contains many posts about sensors which fail to continue working after a low battery. through observing the logs this poster determined the sensors mac address was somehow being corrupted in its RAM , and this one detailed 5 blinks = fail to pair, 3 blinks ok. The wyze sense is based on the TI CC13x0 system on a chip, TI manual link there are a number of references in the manual to resetting it , and the chip itself has a reset pin. [reset] [CC1310] i had 8 (7 c…