Wyze Sense Motion sensor is horribly slow and unresponsive

[HDRock]

These are related

Motion sensor not updating/notifying quickly or accurately representing current state

I have a sensor setup, everything connected fine, good signal on sensor and bridge/camera. (Wyze Pan Cam). I have a sensor sitting on a bathroom wall, facing inwards. So if my kiddo’s run into the bathroom, I know when I need to go help them. (or catch them playing in the sink, etc) The sensor when I first got it was great. Very responsive. Now it takes minutes+ to respond alert. The motion sensor for example says “Motion detected 7:17pm” It’s 7:38 now and no one has been in there for 1…

Repeat notifications for same (past) event

I keep getting the same notifications, repeatedly … Example, “garage motion is clear” at 7:43 p.m. comes in once, then again, then multiple other times at random times for the past hour. Ditto for “garage motion” camera - the notification will say “continuous” and keep notifying me, but there’s no motion, and it’s the same time for the event. I re-started my phone, but it’s still telling me the garage is clear at 7:43 p.m.