Too many Wyze products causing issues

[sodcam]

@billmkline

Then I bought several more sensors, installed 4, and the whole dang thing came crashing down.

I presume that Wyze support suggested this, but just out of curiosity, what happens if you gradually remove the newer items? How long does it take to hit a point where the remaining devices start working properly again, if ever?

@billmkline

i’ve used apps to check my wifi strength, it is strong at the location of any of these devices. I do wonder about the router and, considering that I likely will have to at the very least delete and reinstall the Wyze devices i can keep, getting a new router isn’t out of the question. I will say it worked 100% fine until i added 4 additional contact sensors (which are all now deleted and offline)

OK, so even with all new devices removed, nothing Wyze works? But you can still use the internet with other apps/devices/TVs/etc? So the router doesn’t sound completely fried…

With the good WiFi strength, I presume there’s not a lot of interference / overlap from neighbors, etc?

How hot are your sensor bridges?

How hot does your bridge get?

My contact sensors are acting up and not communicating to the app. I discovered that my bridge is much hotter than I would have expected. I have contacted support twice will see what their thoughts are…

Wyze Bridge Disconnects Non Stop

Come to find out with bridge plugged into the v2 cam it temps go up to 107° or higher. It’s only stable for about an hour at this temp. Higher output power brick, different V2 camera or shorter cable does nothing. The only thing that seems to be working is a foot long USB extension cable from the cam to the bridge so the heat from the camera doesn’t heat up the bridge. In doing this the bridge temp gets no higher then 85.5° and I haven’t had the first drop out. I’ve checked and all my V2 temp…

Yes, delete and reinstall Wyze devices slowly sounds like it might reveal the weak point.