Rule-triggered floodlight breaks motion-detected light

[SlabSlayer]

I believe this was tested in the past by @R.Good and was confirmed to be an issue.

It appears as though when the Floodlight is set to activate on both PIR and camera motion, there is a 10 minute reset period after the rule turns them off. This does not appear to be the case if only one of the activation methods is set to activate.

See these posts that explain the tests and results:

Bug: Floodlight PIR is disabled when switch control Rule is enabled

I just did a test and set my Floodlight up to turn on if I double tap my switch, and turn off when I triple tap my switch [image] I made sure this worked, and turned the floodlight off and on a couple times using the double and triple press. All worked I turned off Motion detection to turn on the floodlight just to test the PIR. And only have PIR turning on the flood light. [image] When I walked past the floodlight the Floodlight came on. I then turned off PIR and set to detect motion on…

Floodlight Camera Question

Welcome to the forum @mooreimaging4. I see this same behavior as well. I am not sure if this is a feature so you can see the camera more clearly at night even though the v3 has starlight or a bug. What I have also noticed is the floodlight does not come on with each access to the camera. For example… I check the camera when it’s dark for the first time, the flood light comes on. If I view the camera again after the Floodlight has gone off, The Floodlight does not come back on. (I have my f…