Garage Door Controller keeps dropping off, must power cycle to restore

Cameras
1

So I recently setup the Wyze Cam V3 with Garage Door Controller.
I’m loving it, and even setup a door sensor on the garage door so it will automatically close it after 10 minutes if I forget.
However, I’ve noticed that every couple of days (sometimes much less) the GDC simply disappears and doesn’t show up at all. Rebooting the V3 camera does not help. I have to power cycle the whole thing to get it back up. I’ve added a Wyze plug so I can reboot it easily…

Is anyone else seeing this?

Cam V3 FW: 4.36.10.2424
GDC FW: 0.10.0.21

2

I am sorry this is happening. I have not personally run across any reports of this happening, have you tried reaching out to support about this?

Wyze Support

(206) 339-9646
Mon - Fri 4am - 8pm PT
Sat - Sun 8am - 4pm PT

3

@debaker1 , Clever idea putting the GDC on a Wyze plug. Bravo.