Extra quarter turn on Pan Cam

OK yall i have something odd going on:
I bought my first Wyze Cam v2 and Wyze Cam Pan on the same day from Amazon Prime on April 24.
I went through the whole .50 shenanigans (which I like to call “motion capture-gate”).
I upgraded the Pan when the .60 firmware upgrade came came out and all was right with the world.
The only thing i thought was strange was how the Pan does this extra quarter turn after you think it is done resetting position and I was hoping the .60 update would fix it.

I thought this was an odd quirk that i would have to live with.

EXCEPT I bought another set of a Pan Cam and a v2 and set them up tonight (May 13) and this Pan cam does NOT do that extra quarter turn at the end of the reset!! What the heck is going on?

I hate that extra quarter turn, how do i make it stop that?
(not sure if it matters but I flashed all 4 of my cameras to have RTSP)

I’d check if a waypoint has been set for the camera and clear it. my camera does the same thing, but by design as I specifically set a single waypoint.

1 Like

No waypoint is set on any of my cams

I made a video of what it is doing, watch the full 11 seconds: