2 cam pan v2 cameras bricked after last update, one a little over a year old and the other less then 5 minutes out of the box. Anyone else having issues
Can you be more specific…what exactly do you mean by bricked? No video? Won’t boot? No access via the app?
No access via app. Was working did update now just sits spinning on attempt 1. Both cameras same
What troubleshooting steps have you tried?
Force stop app and reboot camera. Asked for replacement of new one, guess im sol on the other
Is there a possibility that your SSID password is over 21 characters?
No. It was working then prompted update which I did and that was it. Same issue with older one at different location. Update did them both in
Don’t delete them from your app just yet. Remove the SD Card if there is one installed. Do a factory reset by holding down on the reset button for about 7-10 seconds until the cam reboots. Then do a new device install of the cam.
If that doesn’t work, it may be necessary to do a manual flash of the firmware. Please provide a description of the cam behavior on startup and install attempt.
2 Likes
This solved my issue. My cameras were doing just what yours were and they appeared bricked:
ATTENTION: TurboQAM (QAM256) support in DD-WRT must be turned off for wyze cameras to connect in setup after April, 2023 software updates. Cameras that are running older software stay connected but upgraded cameras or new cameras purchased with newer software WILL NOT CONNECT to a DD-WRT router using TurbQAM (QAM256) support ENABLED on the 2.4GHz WiFi radio. This took me forever to figure out!!