I have a brand new V3 Pro camera. I stepped through the “add device” function in the app and connected it to my Wifi and was then prompted to do a firmware upgrade which I proceeded with. The camera then went into a blue/red flashing mode. I deleted the device in the app and tried to add it again but everything I try fails.
If I try the “add device” function, I eventually get a message saying “cannot find the specific network name”.
If I power cycle the camera, it then goes solid red followed by flashing blue/red again.
If I hold setup for 10s as recommended the camera just goes into “ready to connect” mode, which fails.
If I hold setup for 17s, the camera then goes solid red followed by flashing red. If I then try the “add device” function, I get the same “cannot find the specific network name” again.
As a last resort, I’ve tried to reflash the firmware, but I just end up in the same situation as explained above.
Can anyone suggest a fix for the issue above??
(I have 8 wyze cams and it seems that they’re not as robust as they used to be.)
