Hi there since you seem to be able to help a lot of people I had a quick question…… I just installed two Wyze smart thermostats and I’m having trouble calling for AC. The downstairs thermo had RH, C, W1, Y with G present but not hooked up. The upstairs thermo had RH, W1, Y, G with C present but not hooked up. When I tested the downstairs install it wouldn’t call for heat but it fired on the ac once. This was with the old thermo on the upstairs. When I removed that one and put the Wyze tstat I hooked up the C as it needs power. On the furnace control board zone one has all 5 connected. Zone two has no spot for green. The fuse light bulb glass 20 fuse at the furnace seamed to be messed up so I changed it and turned off the system at the breaker before and then back on to reset it. I still can’t call ac. Should I disconnect the C and use a C converter up on the furnace that Wyze gave me for zone 2 or is there something else wrong?? Here are pictures of my previous wiring. It only lets me upload 1 the other stat had all wires except for C hooked up.
