i have a bridge installed on one of my cameras at one end of the house. and i have a wyze sensor on the other side and its been flakey so i want to move the bridge to another camera closer to the middle of the house.
is it as simple as just unplugged the bridge from where it is now and plugging into the new camera or is there some configuration, deactivation/activation i have to do?
Yup, just plug it in the other camera and it should show up. At least that’s how it worked when I did the same thing. I . would also reboot both cameras
Don’t you have to power them down, to be safe?
That automatically reboots them 
not sure but good points. i wasn’t sure if its was just hot-swappable but best to be safe and power down the camera before removing the bridge. i just wasn’t sure if i plug in on the other camera if it would have to be reconfigured of redetected
It would probably be a good idea. I don’t know if there’s an official rule about hot plugging the bridge, but I’ve done it before several times when I first got Wyze Sense last spring