RTSP BETA RELEASE FOR v3 and Pan v3!

[Crease]

@carverofchoice

Honestly, this is the hard part in some cases.

Yeah, that’s why when I’ve needed to do this I just take the whole thing where I can plug it into a power strip and then just flip the switch while holding the Cam’s SETUP button.

@carverofchoice

For all of mine, I took them down from their mounted position so that I could do this at my desk much more comfortably. For example to use a surge protector outlet near the camera and then you can hold one finger on the reset button and then easily plug in the usb-a cord and adapter into the outlet with just one other hand (Or just flip the switch on the surge protector to power it on).

Yes, exactly like that. (I’m reading as I reply. Not the best way to do this. )

@carverofchoice

@mikebond62

32GB Wyze-branded SD card

I flashed 3 v3s in the last 24hrs with one of these same cards.

For the single Cam Pan v3 I’m testing so far, this is exactly what I used, too.

@mikebond62

At this point I’m operating on the hope that neither of my 32GB-or-less cards are good, and I’ve ordered a couple more 32GB’ers. I get occasional strange messages that the card is defective and needs to be repaired (then when I ‘repair’ it, it says the card was fine).

Have you ever tried using SD Memory Card Formatter in “Overwrite” mode on any of those cards? Take a look at this post and then continue reading the discussion to the end of the topic for more context. It might be worth a shot.