Hello @Ipil60R34s, Yehti and Others.
Yesterday there were posts about adapting boxes to make a camera holder/glare shield and how they may be sawed at an angle to provide sideways and downward camera aims.
I modified my spreadsheet in post No. 59 above to provide a layout cutting pattern for Sq Tube Large Glare Shield. The spreadsheet is functional but not complete. Editing out non-relevant references. The pictures below show progress to date:
Same spreadsheet with calculations for additional cut and fold lines.
Most of the cuts are around the perimeter with two short internal cuts. The five other lines are fold lines. Also, there is a plot for the L Cap.
Start the fit-up around the camera as it needs to fit inside the square sleeve. At this stage, it is taped up at the sleeve corners.
The L Cap is glued on and the large tube is held to it in a square configuration. Later glue is applied to the exposed edges of the camera sleeve joints.
The initial sleeve corner tape was removed and glue applied.
Ready for window trials and then painting.
The spreadsheet should be completed soon.
Victor Maletic.