Hub swap out process?

[R.Good]

Welcome to the forum @acawthon.

I have had to do a Wyze Sense Hub swap in the past, and unfortunately, you will have to add all of the devices back to the new one.

This wishlist item will be of interest. Give it a Vote

Wyze Sense Hub Save/Restore Attached Sensors

I was disappointed to find out pressing the reset switch on the rear of the Sense Hub cleared out the table of sensors causing me to manually reset every one, Several require a ladder to access. Normally devices use this type of switch for a reboot or power cycle reset and not a reset-to-factory action. At the very least it should be a long-press to clear all the configuration. This would not be a problem if users could save the configuration and restore it after a reset. Thanks!