Wyzecam pan v3 doesn't return to detection zone position if motion tracking enabled

[SlabSlayer]

The next Firmware Beta looks to be promising.

This is the last info published by Wyze:

@WyzeJasonJ

Reddit - Wyze Cam Pan v3 does not return to set home position

We have identified other bugs on the firmware that addresses the Waypoint drift issue. Because of this, we haven’t been able to go to beta yet. Due to the security patches that we’ve been allocating our resources to, we have a pushed back timeline for beta. Our most recent plan shows the beta release beginning around the end of November. As always, we’ll keep you in the loop about any changes!