saxnix:
I am having trouble flashing the firmware. I have tried 3 brands of cards (and formatted one of them in a camera as suggested above). All are less than 32GB, have been formatted in Fat32, and I renamed the file to demo.bin.
Upon holding the reset button whilst turning the power on;
Light turns blue after about 4 or 5 seconds,
Release the button and it stays blue for about 50 seconds.
Turns orange for about 5 -10 seconds
“Click click” sound and then it flashes orange indefinitely (until I turn power off).
The camera shows as offline in the Dashboard regardless of if the SD cars is in or removed. When attempting to view the camera feed in the app, error code -90 is shown.
Any ideas?
I just went through this with trying to upgrade a V2
Over on facebook beta testers:
Andy Ly
4 hrs
I figured out how to fix v2 cams that have been bricked. The issue when it boots up with a solid yellow light and after about 30 seconds it just goes off and does nothing. Then ends up rebooting over and over again if you keep it plugged in.
The key to fixing the issue is during boot up once the solid yellow light goes off, immediately push the setup button on the camera. The camera will say ready to connect or something to that effect. By going …
Booted fine, rebooted fine, now shows version 4.28.4.41 and has the RTSP option under Advanced Settings.