Wyze cams dropping off and unable to reconnect to Google Wifi mesh

I have had 2 v1 cams for over a year and used them on a Google mesh network without issue until last week. Both were giving a -90 error and prompt to cycle power, and neither would reconnect (bind fail error) even after complete reboots of everything. I connected them to my FiOS router 2.4 network, bypassing the mesh, which doesn’t allow specifying connect speed. They both work. Now the problem is, one is placed in the garage, where the router signal is adequate to connect, but the other, in my workshop about 70’ behind the house, the router signal doesn’t reach, which is why I went to the mesh network in the first place.

Anyone else had this issue with mesh?

Richard Jones