Power failure corrupted nand?

I experienced a power failure and after the camera came back up, I could not get a picture. After much analysis I suspect the the configuration partition (mtdblock8) was corrupted. This a a quess, but if I am right, is there a procedure to restore the nand to “factory”? Any other thoughts?

Thanks,

Joe

 

Search the support section (link at the top of the page) for Factory Reset. If that doesn’t work, you can flash the firmware (again, search the support section).

I have tried both the factory reset and the firmware (https://www.wyzecam.com/forums/topic/flashing-your-wyzecam-pan-firmware/). No joy. That is why is suspect the nand.

You’ll need to file a support ticket. I’m guessing they’ll probably replace the camera.

@JDonth, I would suspect it is the Land if you have exhausted all options available.