Pan Cam Question

I am new to using the Pan Cam which I have set up in my Garage on top of a cabinet near the door into the house. It can see everything in the garage. My question is what causes it to go to a location when it’s not detecting anything…when it’s not moving? Is there some way to reset where it stops at? Also, is there anyway to stop it’s range of motion from one side to another?

There are a couple of possibilities.

  1. You could have Pan Scan set on. This will cause it to rotate to preset locations automatically
  2. You could have motion tracking on and it senses something as motion. Mine goes nuts over twinkling Christmas tree lights.
  3. You could have a detection zone set and it is trying to return there.

Check this out-Pan Cam Features