Manual firmware upgrade not working

I’m attempting to upgrade the firmware manually on my Wyze Cam v2, for the purposes of RTSP. I’m following the instructions here:

However, when I plug-in the power I never get the blue light. I just get the standard lights and then the “ready to connect” voice.

I know the cam is reading the SD card, because when I take it out it has left behind a few folders. The camera is brand new. It was taken out of the box a couple hours ago, it upgraded to firmware through the app when I was setting it up.

Any ideas?

Welcome to the community!

Are you holding down the setup button when why plug in the camera. You need to do that when installing the RTSP firmware.