Extending Wyze Sense range by soldering on more antennae wire

Hi there, opening up a motion sensor, i can see the aerial on the top edge (similar to the below ) .
scratching the end of the pcb track gives you a surface to solder on, adding some wire i got the bridge to connect from 20m away

does anyone know what frequency this uses? what length of antennae wire is the practical maximum? thanks


I have no personal knowledge about this topic, but it has been discussed over here: Wyze sense / bridge range - #45 by Solardave

Hopefully that helps you.

1 Like

Closing this topic. Discussion can be continued in thread @nerdland referenced. :slight_smile:

1 Like